This was fixed by right clicking the service, properties, log on tab, and changing to "log on as local system account". At first I was not allowed to start the services because when i clicked "start" a log on error appeared. You can use this download page to access GPIB-Serial Converter Software and all available editions are available from this download page. Download GPIB-Serial Converter Software and find support information. The VISA-GPIB interface is supported on Windows ® 10 and not available for macOS or Linux. Install Required Drivers In order to use the VISA-GPIB interface, you must have the required drivers installed for both GPIB and VISA. ![]() Going into services and starting the NI GPIB Enumeration Service, NI LXI Discovery Service, and NI Route Coordinator services as described in the article you provided is what fixed it. The GPIB-Serial Converter Software helps you configure GPIB instrument control devices. You can communicate with GPIB instruments in MATLAB ® by using the VISA-GPIB interface. ![]() If you are unable to see the controller, refer to Cannot Detect NI GPIB-USB HS Device in MAX. If not specified, the controller number defaults to 0. ![]() Secondly, I found a knowledge base article that addresses your issues with the GPIB-USB-HS and outlines a solution. ![]() You can see all supported hardware at this link: There seems to be two separate issues going on right now.įirstly, GPIB-USB-B is not supported hardware for NI 488.2 for Windows 18.5.
0 Comments
Leave a Reply. |